SidsTips puts BLOWZER through a full desk review, from nozzles and speeds to a wind-meter test
In a nearly eight-minute review, Sid of SidsTips unpacks the BLOWZER X6 at his desk, walks through the nozzles, three speeds and trigger, points it at a wind meter, flags heat and noise honestly, then clears leaves off steps outside.
SidsTips received a BLOWZER X6 from us.
A reviewer who tests before he talks
SidsTips is Sid's YouTube channel of gadget reviews and practical how-to tips. He films at a tidy wooden desk in a blue-lit room, with framed mountain photos on the wall behind him. His reviews follow a steady pattern: open the box, show every piece, explain the controls, then go and try the thing somewhere real.
His review of the BLOWZER X6, posted on August 27, 2026, runs just under eight minutes. He says up front that the company sent the unit and that it had been a while since he last tested a cordless duster. The retail box stands at the edge of the frame the whole time.
Every piece on the desk
He starts with the zippered case, then lays out what is inside. The X6 comes with five interchangeable nozzles, and he swaps a couple on camera with a quick twist. "These just come off nice and easily. You just unscrew it, you put another one on and you're good to go," he says.
Next come the charging cable, the brushes and the booklet. He tucks the small parts into the mesh pocket on the lid and presses each nozzle back into its own slot in the foam before zipping the case shut.
Three speeds and a trigger
Then the controls. He reads off the three modes, 40K, 80K and 130K RPM, and points out the battery lights and the USB-C port on the bottom, plus the auto-shutoff. He holds the power button for a couple of seconds, counts the lights, and runs the X6 in the air on each mode.
He also catches a detail many first-time owners miss. "Speed one and two, you can have it run on its own. And speed three, you have to use the trigger," he says. The top mode runs only while you hold it.
A wind meter, and two honest notes
At the four-minute mark he picks up a handheld wind meter, points the cone nozzle at it and reads the numbers out as they climb. He is careful about what a reading like that means: "that can really vary, you know, the way you're holding it, maybe also a difference on the nozzles."
He adds two cautions most reviews skip. After a while the top of the unit "does get a little bit hot to the touch. So just be aware," so he moves his grip lower on the handle. And on the top mode it is loud, which he answers himself: "if you use it for quick bursts it should be fine."
Taking it outside
The last part of the review is a short outdoor reel set to music. The X6 pushes leaves and grit off a sidewalk by a hedge, along a building wall, under a white fence and off a set of concrete steps around his neighbor's apartment.
Back at the desk he is plain about it: "I really didn't have high expectations." He names computers, keyboards and cars as the jobs he would use it for, and says it is no replacement for a full leaf blower on a big yard. For a few leaves on the steps, though, "this may do the trick." His verdict: "I'm impressed with it and this is definitely a winner."
Related
Questions readers ask
Does the BLOWZER X6 have to be held on at the top speed?
Yes. As Sid shows, the 40K and 80K modes run on their own, while the 130K mode runs only while you hold the trigger.
How do you change nozzles on the X6?
Twist one off and twist the next one on. The X6 comes with five interchangeable nozzles, and each has its own slot in the zippered case.
How do you charge it and check the battery?
The X6 has a 4000 mAh battery that charges over USB-C, with battery lights on the bottom and an auto-shutoff.
About the creator
SidsTips @SidsTips
Sid makes SidsTips, a YouTube channel of gadget reviews and practical how-to tips, with a blog at sidstips.com and pages on Facebook and Instagram.
SidsTips received a BLOWZER X6 from us.