How Alvin Ojoy resets his gaming desk, PC and camera gear with BLOWZER

A desk built to be filmed

Alvin Ojoy posts short videos about his desk and the gear on it, on Instagram as @alvinojoy. The setup in this reel is the kind his followers come for: a white desk against a pale wall, a tall plant in the corner, a mechanical keyboard with pink and teal keycaps, a large monitor and an open-sided gaming PC with a GeForce RTX graphics card and a column of white fans. The closing shot pulls back to show the whole room, checkerboard rug included.

The reel runs 35 seconds, cut to music with no voiceover. The words come from text on screen and from his caption, where he writes that an air duster is one of the things he uses every day.

Inside the PC first

It opens on the X6 held up to the lens, then cuts straight to work. Alvin leans into the open case and aims the duster at the CPU cooler and the fans, his free hand on the hardware while the other points the nozzle. A low shot follows the air along the floor of the case, under the fans, where dust likes to settle, and the X6's blue LED glows as he works.

Camera gear and a quick joke

Next he swaps nozzles and picks up a Sony Alpha 7-series camera body in a metal cage, lens off, and points the X6 at the open lens mount. It is the job photographers usually do with a rubber hand blower, done here with a rechargeable tool.

Then the reel takes a breath. Alvin turns the duster on his own face for a second, grinning into the blast, before two title cards show the X6 standing upright on the desk.

The desk reset

The last working shots are the ones most readers will copy. He runs the X6 along the top edge of his monitor, then over a small round desktop speaker beside a potted plant, lifting the fine dust that settles on every flat surface of a desk. To finish, he opens the hard-shell case, lifts out a nozzle to show the attachments, holds the X6 up once more and steps back for the wide shot of the finished setup.

Why it matters for a desk setup

A desk like this gets photographed, filmed and looked at up close, so a film of dust on a monitor or a speaker shows. Alvin's order is a good one to borrow: the inside of the PC first, then the gear you pick up, then the surfaces, so nothing you have already cleaned collects dust from the next job. Hold the fans still while you blow through them, start on a low mode for delicate gear, and leave the camera sensor itself to the camera maker's cleaning advice. The X6 charges over USB-C, so it can live in a drawer by the desk and come out whenever the setup needs a reset.

Related

• How to clean a PC with an air duster
• How to clean a keyboard